ATLAS rubber cap for club hammer with an opening size of 47 x 47 mm, made of 60 Shore soft rubber, suitable for a stoning hammer or club hammer. The rubber of this rubber cap for club hammer has a high clamping capacity.
A rubber cap for club hammer must fit tightly on the hammer head, so it does not tilt during use, fall off, or break. The opening size of a rubber cap for club hammer should therefore be just slightly smaller than the head size of a stoning hammer or club hammer. After installation, the rubber cap for club hammer will bulge very slightly.
On the other hand, a rubber cap for club hammer must not be too small. A rubber cap for club hammer that is too small will break during use.
Measure the head size of your stoning hammer or club hammer squarely in millimeters and check on our website which rubber cap for club hammer is suitable for you. Or bring the stoning hammer or club hammer to one of our dealers and choose the best fitting size there.
A soft rubber ATLAS rubber cap for club hammer is recognizable by the ATLAS logo on the outside.
